secretstore.blogg.se - Plumb bob and level

#Plumb bob and level how to
#Plumb bob and level install
#Plumb bob and level professional

#Plumb bob and level how to

How to use a Segway Reticle Leveler to level your rifle scope: The Segway Reticle Leveler can also be used while shooting to ensure you are holding the gun level, which could be very beneficial on long-range shots. A rubber band goes around the gun and hooks into each of the plastic wings. A spirit level is attached to one of the wings which allows you to make sure your rifle is level. The Segway Reticle Leveler consists of a brass bar that holds two plastic wings with horizontal lines painted on them. It is a very simple device that allows you to level the rifle and scope with just one tool. The Segway Reticle Leveler is the tool that I used when I did my first rifle scope replacement. Rifle Scope Leveling Method 2: Segway Reticle Leveler Again, ensure that both the scope and rifle remain level.

Finally, use a torque wrench to properly torque each screw.

Be sure that the levels on both the receiver and the scope remain level throughout the tightening process. This will reduce the chances of the scope turning while tightening the screws. Only tighten each screw a little bit at a time and alternate between screws.

Next, begin tightening the screws on the scope rings.

Check the level on the receiver to make sure that it is still in position and showing that the firearm itself is level.

Rotate the scope until the level’s bubble is in the middle of the vial.

Remove the cap from the elevation adjustment knob (the one on top of the scope) and place the second line level centered on top of it.

Do not tighten them so much that you cannot adjust the scope. Insert the screws into the scope rings and begin to tighten them.

Place the scope into its bottom rings and sit the ring’s top sections in position.

Secure the gun in place so that it won’t move. Adjust the gun in the cradle or vise until the level’s bubble is in the middle of the vial. Then find a flat place on the receiver or scope base and place one of the line levels onto it.

Set the rifle in a gun cradle or gun vise.How to use line levels to level your rifle scope: You will need two of them to do the job properly. The best line levels to use for leveling a rifle scope are those with aluminum housings, such as these. They consist of a spirit level set into a frame that has hooks to fit over a line. Line levels, also known as string levels, are tools commonly used in construction for leveling over a long distance. Rifle Scope Leveling Method 1: Line Levels Doing these things will help ensure an accident doesn’t happen. Safe means that it isn’t pointed at anyone and no one can accidentally walk in front of it. This will make it impossible for the gun to go off.Īlso, be sure that the gun is pointed in a safe direction as you are working on it. I even like to remove the bolt from the rifle before I begin the process.

#Plumb bob and level install

Safety Firstīefore you attempt to install a scope on a rifle, you must make sure that the gun is unloaded. These steps only detail the actual leveling process. *Note: When following these steps, it is already assumed that the scope rings have been installed onto their base. I have also included some information on how to use a plumb bob to check your work and why it is important to level rifle scopes in the first place. Here is how to use each method to level a rifle scope.

#Plumb bob and level professional

Wheeler Professional Reticle Leveling SystemĮach one of these methods, if done correctly, will help ensure that your rifle scope is level and in line with your rifle’s bore.Three of the most common ways to level a rifle scope are: This will make it easier to sight the scope in and allow you to make accurate adjustments while shooting. If you are going to install a scope on a rifle, you need to make sure that it is level.